Saturday 20 June 2015
Toggle Image On Button
A while ago, i myself wanted to toggle the default images on a command button in access, after searching the internet many solutions stated this was not possible, and that you would need to save the image and then embed it into the project.
For me this was not the solution,It would be time consuming and this only increases the size of your project. So after alot of messing around i found a way of extracting the default images for command buttons and embedding them into a table. (Max size 420kb ish)
With this you can then call any image you want. I have made a project in access that will extract all the data to your project along with instructions on how to use the data.
Once you have downloaded the file open it and you should be presented with the following form
These are all the images that will get exported to your project
I have also included a demo where you can select an image with the combo boxes and then toggle your image.
Disclaimer
This file has been made by Me, Bobby Bates, By downloading this you are agreeing that you are using this of your own accord and that you will test this out on a blank project before implementing into your desired one. I will not be held liable for anything hat could go wrong.
